![]() I wonder if there is a driver issue I am missing? Any ideas?Īnother minor issue, the ports will occasionally switch with NCE going to USB1 as verified by JMRI track power control. I will delete them after this is resolved. ![]() There are screen shots from several screens that may be helpful in the Files section under Dave's QuadLN_S. LocoBuffer USB is on TTYUSB1 as verified by restarting (multiple times) with cable unplugged, and with serial connection set to other options, and using Steve Todd’s USB Polling script. In JMRI the NCE is on TTYUSB0 and JMRI can control track power and run trains. ![]() But can’t Write to sheet from DecoderPro and Rocrail no longer sees occupancy. LocoNet messages appear on LocoNet Monitor and TV LocoNet Activity LEDs flash. Per the manual, disconnected LocoNet cable and no red activity LED flash on the LB. Connected LocoNet from SSB to LB and got second green light. Connected SB-USB to RPi and got green light. Gateway both switches set to on, powered up with green light. Replaced the PR3 and DCS100 with a new LocoBuffer USB from Litchfield Station and an SSB-Gateway from Iron Planet Hobbies setup for Standalone LocoNet. Ran automated train using Rocrail with LocoNet controlling servos and reporting occupancy. Initially setup temporarily with a PR3 and Digitrax DCS100 to provide LocoNet (only LocoNet, no track connection), because they were on hand. Have a layout with NCE PowerPro, RaspberryPi 4B running Steve Todd’s image with JMRI 4.21.5, Tam Valley Quad LN_S decoders and Digikeijs DR4088 detectors.
0 Comments
Leave a Reply. |